Skip to content
Free tool

Relative volume calculator

Enter the numbers for one stock and see its relative volume under the three definitions scanners use.

Shares traded since the open.

For example the 20 day average.

What the stock has normally traded by now.

For example the last completed 5 minute bar.

For example the 12 bars before that one.

Against a full day

0.27x

today so far ÷ average full day

Starts near zero each morning and reaches 1.0 at the close on a normal day.

Against the usual by now

3.00x

today so far ÷ usual by this time

Reads 1.0 at any time of day when the stock is on its normal pace.

Burst

3.00x

last bar ÷ average of earlier bars

Compares right now with a few minutes ago. Fastest to react, and always high at the open.

How to read the three numbers

Relative volume is current volume divided by normal volume. The three results above use the same stock and differ only in what they treat as normal.

The example that loads with the page is a stock at 09:45 that has traded 2.7 million shares. Against its 10 million share average day it reads 0.27. Against the 0.9 million shares it has usually traded by 09:45 it reads 3.00. Both are correct.

The calculator only divides the numbers you enter. It does not estimate a usual volume for you, because that pattern is different for every stock.

For the full explanation, read what relative volume is and how scanners calculate it, or see how a relative volume scan is written.

Questions

How do you calculate relative volume?
Divide current volume by normal volume. The result depends on what you use as normal: the average of a full day, the volume the stock has usually traded by this time of day, or the average of the bars just before the current one.
Why does this calculator show three numbers?
Because scanners use three different definitions under the same name. Seeing them side by side shows how the same stock can read 0.27 on one platform and 3.0 on another.
Where do I find the usual volume by this time of day?
Some platforms show it as cumulative average volume or relative volume at time. If yours does not, add up the volume the stock traded by this time on recent days and take the average.
Build the scan

Write a scan, then run it live

Create the logic once, run it live, and let scanner alerts tell you what changed.

LogicBlocks
Scanner-ready custom calculations
VWAP_HOLD
trade.last > d1.vwap and trade.last > m1.high[t"04:00":t"09:29"].max
in scan
REL_VOL
d1.volume / d1.volume[1:20].mean
column
GAP_PCT
(d1.open - d1.close[1]) / d1.close[1] * 100
filter
RANGE_PCT
(d1.high - d1.low) / d1.low * 100
saved
Used by VWAP Hold3 matches